As an Amazon Associate I earn from qualifying purchases. Some links on this page are affiliate links — if you buy through them, we may earn a commission at no extra cost to you. Read our affiliate disclosure.
A rolling sharpener splits the job in two. A magnetic block holds the knife at a set angle, and a disc on a roller does the grinding as you roll it along the edge. The angle comes from the block, so the blocks are the first thing to compare.
HORL describes 20° as robust sharpness for sturdy blades like European chef's knives, and 15° as a finer edge for hard carbon or Damascus steel. Its FAQ adds a practical test: try 15° for three to five minutes, and if the sharpness isn't satisfactory, go back to 20°. Better still, start from your knife maker's angle in the angle finder. The full table is on sharpening angles by brand.
The picks
Premium · rolling
HORL HORL 2 Rolling Knife Sharpener
15° and 20° per side
2 stages
Serrated: no
Good fit for: 15° and 20° knives with a magnetic angle hold; diamond disc needs no replacing when used properly (maker FAQ).
Variant
Walnut (HO2-NUT)
Type
rolling
Angles
15° and 20° per side
Abrasive and grit
diamond disc + ceramic honing disc
Stages
2
Serrated knives
no
Ceramic knives
yes — hold the angle by hand, since ceramic isn't magnetic (maker FAQ)
Single-bevel knives
not published
Power
manual
Water or oil
none — used dry (maker FAQ)
Warranty
not published
Limits: no serrated knives (maker FAQ); ceramic knives need the angle held by hand.
Skip it if… you need to sharpen serrated knives; your knives are under 15° per side.
Use your knife maker's angle. HORL's own advice: kitchen knives of any quality can be sharpened at 20°; try 15° for three to five minutes and go back to 20° if the sharpness isn't satisfactory.
Do rolling sharpeners work on serrated knives?
Tumbler says no. HORL says the edge should be smooth, without serrations. Work Sharp doesn't say for the RKS.
Specs verified: November 2026 · Updated 2026-11-18 · How we choose